JTAG NAND X WITH J RUNNER

[doggyenterprisev2]

Hey there I have an old dashboad 6. whatever I installed the QSB with flux and some solder.. Im a beginner but i practied before..

My setup XENON old dash installed QSB using Nand x with new V3 code

I use J RUNNER 1.0 beta whichever one

I click on read nand with zenon

then it says can not continue.. what did i do wrong?

IThe PSU is plugged in and thats it and not turned on!

I have nand-x plugged in and nothing is working any ideas?

 

[juanbrnt]

Hey there I have an old dashboad 6. whatever I installed the QSB with flux and some solder.. Im a beginner but i practied before..

My setup XENON old dash installed QSB using Nand x with new V3 code

I use J RUNNER 1.0 beta whichever one

I click on read nand with zenon

then it says can not continue.. what did i do wrong?

IThe PSU is plugged in and thats it and not turned on!

I have nand-x plugged in and nothing is working any ideas?

post pics of u soldering

 

[doggyenterprisev2]

here are the pics

j1f1 i miss a solder point but i fixed it but still can not continue.. maybe i should use jtag tool?

i heard jrunner is poo =(

my soldering skills are beginner spent sometime on it with a 15 watt with flux and 32 dia lead free wire like xecuter said

 

[juanbrnt]

take some q tip with alcohol and clean the flux residues check continuity with a multimeter. try jtag tool but idont think that will make any diference eather u nandx is mess up or you soldering rewiew the points also reset you nand x by pressing the lil botton

 

[doggyenterprisev2]

My nand x is on
driver version 1.12.0.1
driver date 2/29/2008

its the nand x package and says new v3 code
okay il clean the residue

also on jtag j1f1 the pads had no solder.. just a hole.. i filled in solder and soldered the jtag chip.. just to mention for my xenon board.. after this is resolved il jtag old dash jasper lol

please reply if anymore ideas thanks!

---------- Post added at 21:30 ---------- Previous post was at 21:30 ----------

also my NAND X HAS a RED & YELLOW LIGHT regardless whatever I do if this helps

 

[doggyenterprisev2]

hey so im still stuck it says

100% nandpro compatible
new v3 code
I tried using j runner but no luck it says can not continue
then i used nandpro and it says usb intersurface something what do i do

 

[doggyenterprisev2]

f**k YEAH GOT MY NAND TO READ! FIXED MY SOLDERING WITH QSB! WOO HOO THANKS BLAKEY BIG HELP!

 

[doggyenterprisev2]

thanks guys now I got e79 fml im looking into it now! How do I put answered on a thread or delete?

 

[doggyenterprisev2]

solved!

 

[doggyenterprisev2]

update xenon jtag on old dash RROD 0001 =( fml

 

[-DoC-]

Can you post your log?

Also if you took off your heatsinks and just placed them back on to test make sure they are not shorting out on anything.

0001 can be a short somewhere as well.