JTAG Power Pack Red Light Problem.

[iEasterx]

Right so, I jtaged a xenon worked fine, booted into xell, installed freeboot and all was well, Then i decided to close the Case with all the screws, I then went to plug the power pack in and the power pack went red, Does anyone have any idear on what i could do? Thanks.

Things Tried:

Plugged Power Pack In Direct Socket.
Checked For Shorts.

 

[manwithoutname]

You defenitly shorted something there is no doubt about that. Reverse back what you did step at a time and recheck by resetting the PSU by unplugging it and then plugin it in again.

Did you leave any of the NAND wires connected to the board? Did you use direct wiring or QSB?

High resolution pictures of your work would help us a lot.

 

[M AzeeM K]

You defenitly shorted something there is no doubt about that. Reverse back what you did step at a time and recheck by resetting the PSU by unplugging it and then plugin it in again.

Did you leave any of the NAND wires connected to the board? Did you use direct wiring or QSB?

High resolution pictures of your work would help us a lot.

Ditto