jtag qsb alt 1- aud clamp wire

F

frazbo

Full Member
Oct 15, 2011
55
0
Glasgow
hi guys atm im trying to get zephyr to glitch with full fail on all settings with standard jtag qsb set up, so now im gonna write xell with aud clamp and continue testing,its rjtag v1.1 but im using jtag qsb alt v1 because i damaged the v2 that came with the kit and could only obtain the v1 for replacement ,now i cant find any pics or info on how to set this v1 up with the wire installed to Q2N1.
Has anyone used this setup or know where my wiring is placed for this qsb as there are no solder pads for the wire to go.
 
F

frazbo

Full Member
Oct 15, 2011
55
0
Glasgow
im trying to finalize all variations of testing b4 submitting template, therefor just looking for some info on the alt v1 setup to get me to that stage
 
Scrufdog

Scrufdog

VIP Member
Jun 12, 2011
374
0
Baltimore, MD
The jtag qsb settings have no effect on glitch succuss. If you are using Rater and it fails at 21 then it's a glitch issue.

Please fill out out Template with all the information you currently have including pics.
 
F

frazbo

Full Member
Oct 15, 2011
55
0
Glasgow
Thx scrufdog So if install is clean i should be glitching without writing aud clamp.bin, if that's the case ill get a template in motion then because ive tried all 1-6 dips on open,1.2 &1.8 and have changed between the 2 cpu reset points.
 
You must log in or register to reply here.