jtag tool, could not read xell.bin???

[BGAMods]

ok so today ive used the updated jtag tool and everything works fine until i get to write xell and it keeps giving an error, "could not read xell.bin.

dont say its my soldering cause im no noob and wrote manually using nandpro fine.

just wondered if anyone knew why it was doing this?

 

[M AzeeM K]

Did you run Jtag Tool as Administrator ?

 

[BGAMods]

of course. not really sure what it could be. it read the nand fine, created freeboot and wrote freeboot but it just wouldnt write xell. no drama cause i used nandpro but ive got another xenon tomorrow that im gonna test cause ive spoke to cool about it.

 

[M AzeeM K]

I was going to say something...But since you spoke to Cool, its cool

 

[Mrbuzz102]

Same error here, I didn't jst get the error the program hung then stoped working. same as yourslef nandpro worked fine. jst write xell is not working for me either.

 

[J2G]

Flash i wrote xell to the the Xenon that we were taking about few hours ago all fine was using XP ...

Edit and then i look at your post and it says 12 Hours Ago lmao