Yes, as I've said, I followed the tutorial that Fib3r wrote. Everything wrote correctly, from reading & dumping my nand to flashing the .ecc image... I even programmed the CR using the same method he listed.
The console does power on, the green CR light flashes once every so many seconds simultaneously. However after that it just kinda sits in that continuous loop of trying to boot.
I did not however check to see if it boots still without anything written to the nand.
I noticed someone had asked me about why my heatsink is off, that is because I had to remove it to solder the alternative point under the X-Clamp for the CPU_RST (blue wire) Yes, I admit, I messed up that point when I was soldering originally... so I had to use an alternate point to make that connection.
This process has been an absolute headache lol This is my first time ever attempting something like this, I did spend the last month practicing using flux & soldering to just about every point I'd possibly run into while doing this whole procedure on an old junk MB. I'm no pro at these sort of things, but I did do my homework to what I'd thought to have me pretty knowledgeable about this. I figured I'd be good, but this has me really stumped.
