jtag wiring help need alt points

[edokassiah]

hey guys got xb console pre nxe it was never worked on like an attempted jtag etc
i can read and write the nand just fine using my nand x
but everytime i flash a jrunner img i get a e79 error and when i flash back the stock nand it boots fine

im suspecting its my jtag wiring its a xenon console
so i re did it a few times still same issues
im not a complete n00b done numerous jtag and rgh's
can anyone tell me the alt points highlighted in red in the pic

ps i even tried the new wiring method

still doesnt work
be grateful for any help given

 

[Martin C]

There are no alternate points.

Xenon JTAG is possibly the easiest of all consoles. If you suspect that you've damaged any of these points, you should just give it to someone else to do.

 

[evertonman67]

I've ALWAYS used 2x switching diodes from J1F1 to J2D2 points and a 100 ohm resistor from J2D2.4-J2D2.7 and i've NEVER had any problems with doing a Jtag this way.Take off those 3x resistors and replace them with 2x switching diodes and i reckon that should cure your error problem BUT double check all your points wit a multimeter to make sure your getting good constant readouts first

 

[Martin C]

Check J2D2.1 and J2D2.2 - they should be reading at 1.5k with no power connected.

 

[edokassiah]

there is power coming from the j2d2 section looks like j1f1 points are bad can i scratch the traces somewhere and try attaching a wire? since martin c said there is no alt points for the j1f1 section

 

[madhaxer]

Check J2D2.1 and J2D2.2 - they should be reading at 1.5k with no power connected.

How are you getting power from them if there is no power connected?

Can we see a pic of where you messed up the points?