JTAG Jtag works but....

[vinces_xbox]

First I am Jtaging a Zephyr.

I installed the Nand-x pin kit as the boards are jacked.

I used the Jtag Tool to read and wright. All went well.

After installing FreeBoot I booted 360 to see E79. Checked my Jtag wireing and all looked good so I Booted again and this time it booted just fine. It seams to not want to boot about evey other time. (E79)

I have been reading and I think I need to use the alt points as listed in this tut >> http://team-xecuter.com/forums/showthread.php?t=55189&highlight=SMC

I am just looking for confermation befor I redo it all.

Thanks

 

[hodgie]

Did you check the correct smc points on jtag tool? or alt points if applicable.

 

[manwithoutname]

If you have used the original points inc DB1f1 and ROL then it will give random E79 errors whenever you tried to boot. Follow the alternate wiring as in the link you provided and then proceed to installing xell or compiling freeboot with the correct SMC points option selected.