GENERAL jtag

[MBISON564]

hello need help my xbox xenon dont have the sliver points on the t

op for the jtag can it still be jtag

 

[BL4K3Y]

Which dashboard is the console currently running?

You can simply fill the holes with solder which will create the pads needed to solder your wires to .

 

[Martin C]

Silver points are just copper points which were pre-tinned during the manufacturing process. You just need to apply flux and pre-tin the points yourself.

 

[MBISON564]

thanks man

---------- Post added at 21:21 ---------- Previous post was at 21:14 ----------

it on 7371

 

[BL4K3Y]

it on 7371

Then you're all set, see Martin's post .

 

[MBISON564]

i brought nand x instead of ltp do i still need the switch diod and can i use cable wire cause the cat5 to thin and kyier wire ti thuin

 

[BL4K3Y]

The NAND-X comes with everything you need.

 

[MBISON564]

but i am not doing the rgh i am doing jtag

 

[BL4K3Y]

I know, the QSBs in the box are enough to work with, trust me.

Have a look here for some images.

 

[axelll]

taken from: http://www.team-xecuter.com/forums/showthread.php?t=54423

1. NAND-X wiring below:

j1d2.1 = black
j1d2.2 = brown
j1d2.3 = red
j1d2.4 = orange
j1d2.5 = yellow can also be soldered to j2b1.12 both places are ground

J2B1 Header

j2b1.5 = green
j2b2.6 = blue

2. A - use NAND-X Jtag QSB(images in the link above)

OR

2. B - use 330 OHM resistors, soldered as in the first image:

OR

2.C - use 2 switching diodes(1n914, 1N4148) as in the second image

 

[TilVl]

Nand x has qsb for the whole jtag process.

Sent from my SGH-T839 using Tapatalk