- Feb 6, 2012
- 77
- 0
Ohk im going to be reciving a xenon jtagable and i have every thing to do it but do i have to use a ceritain kind of wire or does it matter? also im using a nand-x. and im not using the QSB because they suck !!!
GENERAL Jtagging Wires Question
- Thread starter Road-Runner
- Start date
- Feb 6, 2012
- 77
- 0
if you do not want to use the qsb's you can purchase the wiring from any official reseller
otherwise i suggest you head over to google and figure it out
otherwise i suggest you head over to google and figure it out
you could try 28-30 awg
---------- Post added at 10:16 ---------- Previous post was at 10:15 ----------
Quote: Originally Posted by RROD!
the qsb dont suck it must be your soldering as it is always easyer to blame somthing else???? but the wire you would want to use i geuss anything around 28 to 30 awg
does it have too be a certian gauge ?
Last edited:
Martin C
VIP Member
provided it's small enough to solder between SMD points, it's fine. In fact, the Xenon has no small points to solder to anyway.