Jungle Flasher: No Drive Detected After Erase

[Killians31]

Hey guys,

I have had my 360 on LT 3.0+ for a couple months now, and was in the process of reverting the firmware back to stock to perform an XBL update, but ran into a little bit of an issue here.

I hooked up everything to my desktop, opened up jungle flasher, loaded my original dummy.bin & stock firmware 74850C, spoofed the drive and executed the erase lite-on job.

All was going well, but it appears i was a little slow power cycling the drive. I re-ran the job and the drive seemed to be in 'vendor-mode', however i was unable to write the stock firmware to the drive.

When i re-started the jungle flasher application, im getting 'No drive detected', im also unable to eject my drive.

I really hope i didn't totally f**k the drive on this.

Please help!

Thanks,
Ben

 

[Oggy]

I love this one.

It can't detect a drive as you erased it, not quite sure what else you expect?

Either intro the port that the drive is on, re send the erase, or, read the FAQ in the user guide.

 

[bernzburnz]

Hopefully you didn't plug in the power cable backwards and fry your pcb.