Hi guys, so I restored my drive to stock firmware and now, whenever I load Jungle Flasher, it says "No Drive detected!" I saved the key file, the dummy file, etc.
Can anyone help me?
Can anyone help me?
GENERAL Jungle Flasher "No Drive Detected!"
- Thread starter Reykor
- Start date
reefz3ro
VIP Member
My drive is a Lite-On 93450C.
My setup is Ck3i, Onboard sata and the Probe 3.
I don't have the jf log.. I just tried to restore it to stock firmware and now jf can't detect my drive.
seeing as you have a ck3i, try clicking on "liteon erase" and see if it goes into vendor mode. report back but dont do anything after that
dale
Next to the power switch there's a green light. Between the Eject and MODE B buttons is a red light.
mode b should be blue. click on mode b and change it. although thats not the problem. you should have two green lights, one being power and the other indicating that ck3i is enabled. Have you got additional functions ticked in dvdkey32 tab ? (top right)
dale
No, I didn't have the Additional functions ticked..
You're telling me to press the mode b button?
You're telling me to press the mode b button?
yes, it should be blue light, not red, then click on liteon erase again and tell me what you get
dale
No luck..
It shows: "Sending Lite-On-Erase request to port 0x09F0
..
Drive Returned Status 0x7F
.............................
Device Intro Failed!
It shows: "Sending Lite-On-Erase request to port 0x09F0
..
Drive Returned Status 0x7F
.............................
Device Intro Failed!
Hah! Silly me. Tried the other primary port and now it appears that the drive is in vendor mode!
What should I do now?
What should I do now?
load your dummy.bin in source and dont accept auto load.
click on manual and look for the correct stock fw for your drive. load that to target and click "spoof to target"
make sure both keys match then click on write. once done click on outro. job done
dale
Many many thanks dale! My drive finally appears. The DVD Key says Not Found but I read here in the Xecuter Forums that it isn't a problem.
Again, many thanks!
Cheers,
Rui
Again, many thanks!
Cheers,
Rui
that should be fine, sometimes it will say that. Ive had it a few times too.
pleased your all sorted
dale