Jungle flasher not recognizing my Benq???

[kevinxray]

Im running jungle flasher on windows xp. Im going to tell you step by step what i do and plz tell me if im doing something wrong. also im powering this from my xbox360

1. download the drivers successfully for my x360 usb pro
2. Download jungle flasher
3.put the liusb.dll where the jungle flasher.exe directory is at
4.Put the modded firmware where it siads "Firmware" in the folder
5.Start jungle flasher
6.turn on my xbox360
7.on jungle flasher i go to "mtk flash 32"
8. i look in driver properties and siads "no driver detected"

ANOTHER QUESTION:
i use x360 usb pro. when i turn on my xbox360, the x360 usb pro flashes a little blue light. My question is, should that light stay flashing on, and if so how?

 

[besty]

Hi I had that with one my benq i found mine by pressing intro/device id .

 

[BL4K3Y]

Remove "LibUSB0.dll" from the JungleFlasher directory, this is installed along with the X360USB Pro drivers and will cause issues if it coexists in both System32 and the JungleFlasher directory.

 

[kevinxray]

Remove "LibUSB0.dll" from the JungleFlasher directory, this is installed along with the X360USB Pro drivers and will cause issues if it coexists in both System32 and the JungleFlasher directory.

i dont think it install cause it tells me "the program cant start because libusb0.dll is missing from you computer. try reinstalling the program to fix this problem." What do i do?

 

[BL4K3Y]

You need to install your USB Pro drivers correctly - follow this tutorial.

 

[kevinxray]

You need to install your USB Pro drivers correctly - follow this tutorial.

I like the tutorial but i ran into another problem.. it tells me
"Windoes was unable to install your x360usb pio
Windoes could not find driver software for your device.
If you know the manufacturer of your device, you can visit its website and chek the support section for driver software"

ALSO: this is Windows 7 64 bit

 

[johnccc]

Hi I had that with one my benq i found mine by pressing intro/device id .

Try the above, you could have messed up your drives firmware, connect your drive, click intro, then on the dialog, click yes, power off the drive, then power on the drive, it should show up in vendor mode, write your firmware, then outro the drive.