FIXED JungleFlasher fails Intro

[hellooldchap42]

I have a LITEON DG-16D2S flashed to LT+ firmware. I recently installed an x k3y and no longer need the CFW on the drive. But when I plug in the drive (using an X360USB Pro V2) and click "Intro/Device ID", it always fails. I do cycle the power to the drive each time and it never works. I have tried cycling the power via the power switch on the X360USB Pro V2 and also with the button on my Probe 3. Neither worked. Does anyone have suggestions?

Using Windows 7 in test mode, JungleFlasher 0.1.92 (I know its outdated, but I couldn't find an updated download), X360USB Pro V2, and Probe 3.

 

[DreamZ]

have you tried to select 0x0000 from the drop down box in dvdkey32?
helps "refresh" i always do that after connecting a drive

 

[Martin C]

you cannot intro a DG-16D2S when it has firmware on it. You need to erase it first.

 

[hellooldchap42]

So I HAVE to click "Lite-On Erase" in the MTK Flash 32 tab to flash back to stock? I almost did that but it said it would send an intro signal the drive after erasing it. To which I would have to reset the power to the drive. Since it didn't work the other way, I got nervous. I haven't dealt with any of this in about 6 months so I'm forgetting some of the steps I used before.

 

[Martin C]

So I HAVE to click "Lite-On Erase" in the MTK Flash 32 tab to flash back to stock? I almost did that but it said it would send an intro signal the drive after erasing it. To which I would have to reset the power to the drive. Since it didn't work the other way, I got nervous. I haven't dealt with any of this in about 6 months so I'm forgetting some of the steps I used before.

Do you already have the DVD key??

 

[hellooldchap42]

Yes I do. I loaded the dummy into the source and the stock firmware into target and spoofed the key. You were correct in stating that I had to click erase instead of intro. Thank you. My problem is solved!