ANSWERED JungleFlasher Status 0xFF

[Pseudonymous]

My power went out during an erase of 0800 to LT v3.0 and JF log didn't save the log. Now my PC will not recognize the drive nor will JF.

I Tried "Erase Liteon" and power cycling to go into Vendor mode but, sadly no luck. A Status of 0xFF shows up.

Any Ideas?

I'm not familiar with Iprep but I've seen some videos of people fixing their drives after a bad erase or Flash.

The disk tray ejects and I have The drive key.

The only solution people seem to have is "Liteon Erase" and power cycling to get into vendor mode. :facepalm:

 

[Astromine]

Assuming you have the drive's dummy.bin load that as source fw and then load the drive's stock fw as target, spoof source to target, liteon erase, power cycle, write and then outro.

 

[Martin C]

My power went out during an erase of 0800 to LT v3.0 and JF log didn't save the log. Now my PC will not recognize the drive nor will JF.

I Tried "Erase Liteon" and power cycling to go into Vendor mode but, sadly no luck. A Status of 0xFF shows up.

Any Ideas?

I'm not familiar with Iprep but I've seen some videos of people fixing their drives after a bad erase or Flash.

The disk tray ejects and I have The drive key.

The only solution people seem to have is "Liteon Erase" and power cycling to get into vendor mode. :facepalm:

Get an X360USBPro - that's why we use them.

If the tray ejects, the firmware is still on there and nothing has been erased.

 

[Pseudonymous]

Issue fixed. I Restarted my PC a few times and it recognized it. Flashed and back in the box where it belongs... I thought she was a goner. The issue fixed itself. Appreciate you guys trying to help tho,no doubt.

 

[metaljay]

ah the old 'reboot' trick lol
fixes some many unknown issues...