Just installed X3 on 1.6, now what?

[shud]

Oh, hey, someone else that had the same problem as me:

http://www.teamxecuter.com/index.php?name=Forums&file=viewtopic&t=23537&highlight=amber

Doesn't seem to be any solution out there that anyone has found.

 

[nemesys2002]

Well, from what I see, you have a 1.6b xbox, but I could be wrong. Check your RAM, if it is Hynex, then it is a 1.6b which means you need to use flashbios 3.0.3 available from the download section of this website.

Get it, flash it, try it.

 

[Slawek]

I'm not very good at any of this yet, but I'll try to give my opinion to aid you. Judging from your manufacture date, you have a 1.6b xbox. You need a different bios than the 1.6. In the left menu of the screen there is Latest Bios Versions, and FlashBIOS v3.0.3 - 256k. I believe that's the one you need.

Good luck, hope you didn't fudge anything!

 

[ureterral]

I need to be on a bank that is at least 1MB, correct? So my only other option seems to be the 2MB bank. Is that dangerous in any way?

Are you kidding?
When you flash 2 1MB Bios's, Bank 1 is the 1st 1MB and Bank2 is the 2nd 1MB. And yeah remember to flash the _16 version of the bios if u have a 1.6.

 

[orchidpsycho]

Warning!

hi again, i am using the pogo mo thoin(NON-cap) tutorial and i dont understand the erase warning that said: sending the erase command to the lite on using via card with drivers installed poses potential risk of the system... i have a via VT6421 RAID controller. i can do the erasing without problem?? and in the same page in the tutorial said: NOTE- you cannot spoof a lite on drive with LT firmware as a different drive. how i know when i am spoofing a drive with LT firmware as a differnt drive?

 

[camo]

What??? repost with a bit of grammar and spell check and i might be able to help you mate..

 

[xvanwilderx]

If you don't know whether you are spoofing a drive or not, then you are NOT. If you were spoofing a drive, you would know! The Jungle Flasher Tutorial has a section that goes over spoofing drives, the section you are reading is going through flashing your drive with the latest firmware (no spoofing). This part of the PMT tutorial is taken from the Jungle Flasher tutorial.

I would suggest you go through the Jungle Flasher tutorial for erasing and writing to your LiteOn drive. It will look like this:

This is very easy to understand, you just click on the link and it will tell you how to properly remove the drivers for you VIA card so you can successfully flash your drive.

EDIT: Also, regarding the title of your topic, "Warning!", it is not descriptive at all. You should change it to something like "How to flash LiteOn with VIA card" or "Help, warning when flashing LiteOn with VIA card".