Just stopped booting modified

[chiefrcrtr]

Well, thought I had successfully installed X3. Steady blue indicator. Switched to another monitor, now it will only boot unmodified (Red) and the Eject button flashes red & green. When I try to boot with quick push to power button, it cycles on and off but won't go blue. Any suggestions?

 

[psilocybe]

sounds like one of your connections came loose

 

[chiefrcrtr]

Well, just about like everyone else with a FRAG (Flashing Red And Green) problem, I went back to the pin header and resoldered it. Originally I was extremely light on the solder because I had read it didn't take much---wrong. Need to make sure you have an ample solder point. Don't go nuts, but don't just make it shiney with solder either. Works like a champ----taa daa.........now to Flash (oh boy) Thanks and good luck all!

 

[yac747]

Spoofed BenQ won't open after Flashing - Wont go to ven

Hi Guys

Yesterday I flashed my first DVD Drive. I extracted my DVD key from my Hitachi 79, Then connected unlocked and spoofed my BenQ drive (Using Hitachi key and LT V1.2) JF told me everything had gone well and passed the verification checks. I then reconnected everything back to the TV and the DVD drive simply wouldn't open, I then reconnected the BenQ to my PC and tried to put it into Vendor mode however none of the options will work for me (I can't use the halfway DVD drive trick as it wont open! - which is what I originally used to put it into vendor mode)

Does anyone know how I can fix this? As I can't erase the current / write orinigal FW as I can't get it into vendor mode

All help appricaited

James