ANSWERED Just would like a quick confirmation before I begin soldering

[Acester47]

Hey guys, I'm about to install 2 of the QSB's and I'd just like a quick confirmation before I start soldering.. I took 2 pictures, 1 of each QSB, one is on J1D2, one is on J2B1.. The mobo is a Xenon. I am assuming I solder each silver spot to the board? Or is there some that I shouldn't touch? Thanks, any help is appreciated. My first time.

 

[BGAMods]

theres 5 on j1d2 and 6 on j2b1. just solder the silver pads on the qsb to the corresponding hole. simple as.

 

[Acester47]

so it's all lined up correctly? I've seen other pictures of J2B1 located differently, but I am assuming because it was a different mobo?

 

[BGAMods]

that looks the same to me.

 

[Acester47]

It actually dosn't look the same to me, which is why I started this thread in the first place.. I noticed in that picture that the little brown SMD just below the (TX) logo on J2B1 is in an upper position, while mine it's down lower.. I was just wondering why, and I don't like screwing things up, so I thought may as well ask, right? Anyway, I'll assume it doesn't really matter and heat up the solder gun, thanks.

 

[big_ted]

the points for reading and writing as in the above picture are the same for all the boards excluding the new s

Ted