Hi. I did my second slim flash on a brand new xbox. My first slim i did successfully, this one not so good. Please help.
This was a brand new out of the box, the 0401 drive,i put the dash to 14719, did kamakaze knife mod, drive unlocked 0x00 perfect, retrieved dummy and OFW, flashed to LT3.0 and locked drive per JF tut. When i switched xbox the orig and backups give Open Tray only. Drive ejects perfect but it seems i may have knifed a tad too deep which seems like the motor thing not working. This i gathered from all feedback on various forums.
So i have a 0225 unlocked pcb (Green one not the TX) handy that was kamikaze from my friend, that i would like to now replace in my xbox.
Please could u advise the process to follow here ie what to load into source, target, etc and the steps prior to me replacing the pcb on my drive? Do i just connect the loose unlucked pcb to JF first before placing replacing. And what abt the key from my orig pcb? Im a bit (ok very) confused and would appreciate any help that you guys can give. Also i believe i need to solder some wires, i have a soldering iron but never soldered or desoldered before. Is this very easy?
Im using X360 pro and CK3i and latest JF.
This was a brand new out of the box, the 0401 drive,i put the dash to 14719, did kamakaze knife mod, drive unlocked 0x00 perfect, retrieved dummy and OFW, flashed to LT3.0 and locked drive per JF tut. When i switched xbox the orig and backups give Open Tray only. Drive ejects perfect but it seems i may have knifed a tad too deep which seems like the motor thing not working. This i gathered from all feedback on various forums.
So i have a 0225 unlocked pcb (Green one not the TX) handy that was kamikaze from my friend, that i would like to now replace in my xbox.
Please could u advise the process to follow here ie what to load into source, target, etc and the steps prior to me replacing the pcb on my drive? Do i just connect the loose unlucked pcb to JF first before placing replacing. And what abt the key from my orig pcb? Im a bit (ok very) confused and would appreciate any help that you guys can give. Also i believe i need to solder some wires, i have a soldering iron but never soldered or desoldered before. Is this very easy?
Im using X360 pro and CK3i and latest JF.