ANSWERED kamikaze specifics

ballinballinballin

Junior Member
Dec 21, 2011
11
0
U.S.A.
i was reading the jungleflasher tutorial about unlocking the winbond chip and had some questions. the 3.3v on the dremel we are supposed to drill with. it said we can access the voltage from the pcb with soldering or from the power cable in the ck3 cables. would it be possibe to use the probe 3 touching the dremel bit to supply the 3.3v of power?
on another note, on the sputnik probe, what are the 4 switches for and how are they supposed to be set to unlock the mxic chip?
 

reefz3ro

VIP Member
May 30, 2011
669
0
Pittsburgh, PA
i dont believe you need the 3.3v anymore with the new JF just drill it i use a pin vise with a 3/64 drill bit or .5mm

the switches on the probe are resistances some pcbs are a little different and need different settings
 

d4m4n

Junior Member
Aug 6, 2011
10
0
Remember to have the in line resistor where ever you take the 3.3V.
 

J2G

VIP Member
May 13, 2010
3,737
0
90°N
www.esl-communications.com
can anyone confirm that you dont need the 3.3v anymore? and if not, im curious as to why that is no longer needed.
maybe if you read what was posted above you and read the rules on thread hi-jacking would have answered your questions :facepalm: