LAD2 Help

[KoVaH]

This is my first time installing a mod chip, and my opinion is that the comments on the main page were entirely fictional. I made it all the way until the LAD2 wire solder point. The problem is there is nothing to solder the wire to, and in my attempt a piece of plastic was melted onto the board and covered up the "hole" If anyone can offer any advice on how to clean up the melted plastic it would be much appreciated.

 

[1911Wolf]

This is my first time installing a mod chip, and my opinion is that the comments on the main page were entirely fictional. I made it all the way until the LAD2 wire solder point. The problem is there is nothing to solder the wire to, and in my attempt a piece of plastic was melted onto the board and covered up the "hole" If anyone can offer any advice on how to clean up the melted plastic it would be much appreciated.

So, you screw up your v1.6 install then call everybody's success stories “fictional” because they didn’t screw up like you?

And yes, there is something to solder to for LAD2 clearly shown in the tutorial: http://www.teamxecuter.com/x3/tutorials/x3pin16.htm

If it is just plastic that melted over the area, get a magnifying glass and carefully scrape it off with a finger nail or small tool.

 

[paulbautista]

Need help to spoof my liteon

Hi,

i have been searching here and the net for guides to spoofing my liteon, the reason being that i ran last nights update Doh and have been ap2.5 flagged, i have 2 xboxs both with the liteon 74's one drive is dead laser died, i have already extracted the files from this drive, the one thats ap2.5 flagged is going to be banned so i want to replace the drive for the one that has already died, but cant find tut's for this i can find tut's for benq to liteon sammy to liteon but not liteon to liteon, any advice would be great first post ever and i have been using this site for over 2years

 

[strucdown]

Re: Need help to spoof my liteon

load the dummy.bin in the top box in jf then load the lt+1.1 in the bottom box then click on the spoof source to target then check that both the keys are the same in both sections ifso save then proceed to flash as normal

 

[paulbautista]

Re: Need help to spoof my liteon

midiandy when you say load the dummy.bin do you mean the drive thats broken that i want to replace or the dummy.bin for the working drive??

 

[strucdown]

Re: Need help to spoof my liteon

get the dummy.bin from the broken drive then follow as i said

 

[paulbautista]

Re: Need help to spoof my liteon

thanks midiandy, after having a big fat spliff if worked out what you meant been up and running since last night, again a big thanks for replying

 

[strucdown]

Re: Need help to spoof my liteon

no probs enjoy your newly flash console