Lifted Pads

[anthonyp]

I just purchased the CR4 and lifted one of the pads on the back of the xbox board (the one where the white cable goes). My next logical step is to trace the point, but having a tough time finding the lead on the board. Can anyone tell me if i can jump this on another location on the board?

Here's a pic --> http://xecuter.com/cr4/CR4_PHAT_3.png

 

[john mathews]

I replied to your thread y open another with the same ?:facepalm:

 

[GeekHeat]

Solder to the resistor right next to it.
Google PLL bypass alternative point.

 

[anthonyp]

Awesome! Thanks. I got the resistor soldered on one end and the other end to cpu_pll_bypass (confirmed good connections with multimeter), but while i was putting on the heat sink the blue wire snagged - ripping off the cpu_rst pad! Do you have an alternative solder point for this?

Some threads say it should boot into retail even, but I'm getting 3 lights.

picture: https://www.dropbox.com/s/3rmexbtduc1pxib/IMG_2631 copy.jpg?dl=0


​

 

[Running4Hippos]

[FONT=Verdana, Arial, sans-serif]You have a phat correct?

Try this [/FONT]http://team-xecuter.com/forums/threads/87092-CPU_RST-alt-point-on-phat

WNYCONSOLES comment says how you can fix it

 

[anthonyp]

I have the phat. Just to clarify - is it safe to say the trace wire is between the resistor and the lifted pad? Also wire I should wire the trace to the left lead on R8C2?

Here's a pic of my assumption --> https://dl.dropboxusercontent.com/u/33442631/CR4_PHAT_3 (1).jpg

 

[Running4Hippos]

I have the phat. Just to clarify - is it safe to say the trace wire is between the resistor and the lifted pad? Also wire I should wire the trace to the left lead on R8C2?

Here's a pic of my assumption --> https://dl.dropboxusercontent.com/u/33442631/CR4_PHAT_3 (1).jpg

I'm not 100% sure as I have only worked on slims, but if you only lifted the pad and you didn't ruin the trace you don't have to wire the the trace to the left lead on R8C2

Here I hope this photo helps on the alt point for cpu_rst, its just a visual

http://goo.gl/A8Vk55

 

[anthonyp]

That's good news. I was thinking I had to scrape and jump the trace. So I'll just run my CR4 to the left lea on R8C2. I'll let you know how it turns out.