RGH Lifted PLL Resistor, Should it boot with ALT?

[WNYConsoles]

I received an XBOX today for failed RGH repair. All RGH points were damaged and the unit would not boot, however I was able to use an alternate point and repair some other points to get the XBOX to boot.

It is a Falcon and at this time it boots to 2nd ROL cycle then posts 2RROD 0001 (Power issue).

My main question is, can/should the XBOX boot with the PLL resistor missing using alternate PLL point on top of board?

As of right now this is my wiring layout...

Original RST to CR
Original POST_OUT1 to CR
Alternate PLL (TOP) to CR
STBY_CLK to CR

 

[x360ccm]

it's a 10k resistor.replace it.

then boot only if you fixed it.post pics of it and the repairs or damage points

 

[WNYConsoles]

Would be hard to replace it as both original PPL, resistor, and both resistor pads are gone. I there a way to add the resistor using the alt point?



EDIT: Added 10k OHM in-line with RST and ALT PLL and she booted!

 

[cicero44bc]

Nice one SexDrugsOverclocking, sounds satisfying!

 

[RROD!]

Best if you post a pic so we can see if you have any trace left if so then try to clean up and use a thru hole resistor and solder the legs to the trace but again would have to see a pic first

 

[x360ccm]

Would be hard to replace it as both original PPL, resistor, and both resistor pads are gone. I there a way to add the resistor using the alt point?



EDIT: Added 10k OHM in-line with RST and ALT PLL and she booted!

post your pics:biggrin:

 

[cicero44bc]

post your pics:biggrin:

Ooo pics, seconded!

 

[WNYConsoles]

Here are pictures of my install. The console, which is a Falcon, boots perfectly now.

Pictures - http://wnyconsoleservices.com/photogallery/index.php/PLL_Resistor_Repair

Using:
Original RST to CR
Original POST_OUT1 to CR
Alternate PLL (TOP) to CR with missing resistor. Added 10k ohm resistor in-line from CR to PLL wire (green).
STBY_CLK to CR