I tried installed an LT switch on this drive and I am having issues. For some reason solder is just not sticking to one of the connections. I think I have the traces cut properly. Anyway I am on my second LT switch and I was wondering if someone could properly install it and flash it with the latest firmware for me. I was also wondering if they can provide me with a cd of the original firmware so that I can flash the drive myself in the future. I have already installed the blaster CK3 in this xbox and I'd really like to start using it soon since it is just sitting here. Please PM me I am located in Blacksburg, VA and will ship the drive. Please let me know I'd pay more for this to be done as soon as possible.
Lite On 93450c flashing
- Thread starter Pgherardi
- Start date
Yea I did, solder stuck when I put on the first LT switch but I had the traces not cut well enough so I had to take it off and it ended up ruining that chip. Now I think there is rosin or something on the connection that I can't seem to clean off so I figured I just ask for help.
I tried I don't want to take the switch off again so I have limited room to work with. Is there a possibility that I sanded too much? or is that very difficult to do. The switch toggles between red and green so I know my traces are correct. I suspect its just this one missing connection.
sick360mods
BANNED
Anybody in the US willing to flash this for me? PM me or send an email to [email protected]. It would be really appreciated!
Ubergeek
Xecuter Groupie
Solder not "sticking" = you have not cleaned the traces and fluxed. Thats it end of story absolutley nothing else.