ANSWERED Lite-on bad flash recovery?

[rastaban]

Hello can someone help.Ok ive been doing firmware mod for a while.so i know what im doing.I was flashing a lite on from a phat 360.My power went off during writing and now i would like to know how to proceed.It happen to me before with benq and i was able to fix.

 

[aizatgames]

does it detect the drive in JF ??

 

[rastaban]

no not anymore.

 

[mm53668]

Just make sure port is select - send lo-erase and it should bring it into vendor mode - assuming you saved the key of course

 

[HcKrSklz]

Hello can someone help.Ok ive been doing firmware mod for a while.so i know what im doing.I was flashing a lite on from a phat 360.My power went off during writing and now i would like to know how to proceed.It happen to me before with benq and i was able to fix.

All you have to do is send the drive an intro. Give that a try then do the usual phat key ect.

 

[rastaban]

R u saying to hit lite on erase instead of device intro?

 

[n1ght0wl]

have you got the key a dummy.bin ? if so hit liteon erase

 

[daman10]

load the dummy.bin into the source then the lt3.0 into the target then try intro

 

[mm53668]

R u saying to hit lite on erase instead of device intro?

Yes if it locked up and wont open because of partial write and is not recognized just hit LO- Erase it will move to vendor mode and allow you to start over the write process

 

[rastaban]

Got it working thanks guys .