Lite-On DG-16D5S burned component (need help to ID value)

[JustFixinStuff]

Okay, this is a rare instance that I rushed when flashing a friend's 360 slim and I fried a component and could use the help of you experienced guys in identifying the value of it. It's one of the components located at C6 and seems to be in line with the power connector. I know I didn't insert the power connector in backwards but that may very well have been the case. Any help would be greatly appreciated, thanks! Pic of the component should show below.

I have plenty of broken circuit boards that I can maybe extract the component from, but seeing as I cannot locate my multimeter, I come to you guys for some help. Thanks in advance!

 

[tomma66]

If that is a DG16-D5S you cant kamikaze them.

 

[jsinger47]

If that is a DG16-D5S you cant kamikaze them.

You must be blind. Clearly D4s.

It is a 6v 100uf cap you fried by plugging in upside down.

Also, a 0ohm resistor.


In the case of a spelling error, I blame Tapatalk.

 

[tomma66]

I was just going from the title the op put.

 

[XMonsterModsX]

i dont know what you was using to do the kamikaze but the hole is way to big

 

[JustFixinStuff]

Correction... 4DS indeed. I copied and pasted from the wrong LiteOn version in my clipboard. Okay, so thanks for the info guys, I'm digging through my extra parts pile for a similar component and know I can simply bridge the point that blew the 0 ohm resistor, right?

As for the Kamikaze attempt, it went just fine. The hole looks way too big because I started it off with the Dremel method but then my template came in so I did the rest with an Xacto knife. You guys do indeed have an eye for that stuff but rest assured, it went smoothly.