Well i followed the step by step guide to extract the key from the drive. I was about to start flashing the firmware on to the Drive. When i got into MTK Flash 32 i couldn't find my drive in the drop down box. I tried to press the eject button my the CK3 Lite except it wouldn't up. I tried using the CK3 Lite on my other Lite-On drive and it would open up. Someone please help me to fix this?
LITEON 74850 Lite-On Drive won't power up after extracting key
- Thread starter lilvi3tkyd
- Start date
BL4K3Y
VIP Member
If you have the correct drive key (dummy.bin), click Lite-On erase and follow the prompts. When it prompts you to power cycle, do so and JungleFlasher should show status 0x72 (Vendor mode), from here you can write new firmware to your drive.
Oh, and don't forget to click Outro/ATA Reset once the write verifies
.
Oh, and don't forget to click Outro/ATA Reset once the write verifies
.I tried to do that except it didn't work the first time and then i tried restarting my computer. I'm back onto juggle flasher and I'm trying to find my drive on the I/O Port drop box except it not showing up. The CK3 lite and Sata cable work except my drive is showing up for some reason and i disabled the driver(yellow "!")
BL4K3Y
VIP Member
Yeah, i just clicked it now. I flashed my Benq drive before and a Hitachi so i know which port it is and when i have my selected port, no drive detected. Do you think there maybe something wrong with my drive not powering up?
BL4K3Y
VIP Member