LITEON DG-16D2S Liteon 0251c 0xD0 status

[iSTEAMY69]

My drive keeps getting the 0x80 on jungleflasher 1.88 and it wont do any thing I click erase and it just says device intro failed.I don't no what to do or how to fix it.When 1.89 come out now it just says 0xD0 and still says device intro failed any ideas thanks :smile:

 

[knowlzy10]

a little more info would help drive? jf log, also what setup are you using?

 

[iSTEAMY69]

ck3 pro via 2641 chip set I falsh ed 5 drives no problem this one wont work :'(

 

[diaboliq20]

has it been flashed before - did u have a bad flash??

 

[iSTEAMY69]

has it been flashed before - did u have a bad flash??

Yes was lt 1.1 then 1.9 then I tried flashing 2.0 but the pc crashed half way throw writing it and never worked again :facepalm:

 

[knowlzy10]

if it crashed have way through is the drive still showing up in jf?

 

[diaboliq20]

have a quick read through page 201 of the jf tut - see if that helps u out first

 

[iSTEAMY69]

no not at all :'( but when I click liteon erase it comes up as 0xD0

 

[knowlzy10]

have a quick read through page 201 of the jf tut - see if that helps u out first

read it:rolleyes2:

but page 201 was benq bad flash, im guessing liteon must be the same is it? luckily not had one yet

 

[diaboliq20]

or
try treating the drive as an untouched one - use the probe to intro the drive.....

---------- Post added at 15:08 ---------- Previous post was at 15:07 ----------

hit liteon erase, and power cycle the drive - see if that works

 

[knowlzy10]

no not at all :'( but when I click liteon erase it comes up as 0xD0

is the drive still stuck in vendor mode? try power cycling the drive and qutro reset

 

[iSTEAMY69]

have a quick read through page 201 of the jf tut - see if that helps u out first

OMFG you are a wizard it work

 

[diaboliq20]

cool beans - glad ur working