thanks dale not done that will it let me? whats the best way please sorry to be such a noobie
Powering off the drive with the CK3 Pro Power switch does not work. It fails every time but if I use the switch in the Probe 3 cable to turn off and on it works 100% of the time. I know the tutorial does make a note of that but shouldn't the tutorial be updated to remove the statement about powering off the drive from the CK3 Pro or whatever board is being used to power up the drive. Maybe this works for others but 100% of the time it does not work this way for me. I have the exact setup as pictured in the tutorial.
Second question. I tried to put back the Stock Firmware for the 74850C. I think I am doing something wrong. In the source field do I put the dummy.bin and in the target field the Stock.bin? Then proceed to erase and write?
With the CK3 Pro back in November I did save the dummy.bin and a bunch of other files where saved along with that dummy.bin such as a key file etc etc.
I am still searching for a short tutorial on putting the drive back to stock with the new X360USB Pro. I know there is a section in the main manual about this but for CK3 Pro not the USB one.