Liteon DG-16D4S TX PCB Wont open tray

[Threpwhistle]

Good afternoon

I have fitted the TX PCB 1.1 to my Slim liteon. I have flashed it following Ubergeeks guide using my USBPRO and CK3i but i cant eject the tray? The flash has worked as i can put a disk in when stripped then built up and it will play. I have continuity checked my wiring from the red, white and green wires from the drive up to the PCB also the black and red from the block screws to the PCB which has 0 ohms good continuity? I did notice some of the soldering at the power end connector for the drive of the PCB are touching but i dont know if this is normal as this is the first PCB i have fitted. Any advice would be appreciated, Thanks.

 

[Threpwhistle]

Hi all,

just wonderd if any one could point me in what i may have done wrong with fitting this PCB?

 

[loaderbull]

Hi,

I do believe those points/joints are not supposed to be bridging.

 

[Dicko316]

Yeah mate, be careful, none of those points on the dvd drive cable connector should be touching. Either send it back or clean it up.

 

[Antalpromille]

Youre on something about those solder bridges, check them out and see that they are not shortig different voltages. I would have checked myself but im on my way to bed now.

 

[Dicko316]

Also WTF is the WP switch lol, is it a fake? where did you buy it?

 

[loaderbull]

Also WTF is the WP switch lol, is it a fake? where did you buy it?

That's the new TX PCB with switch (version 1.1 as he said in original post)

 

[Dicko316]

Ahh yeah, external switch, forgot about that :facepalm:

But still WTF is with the power connector?

 

[abyss]

where did you buy the board?
could be something with the board or check those wires perhaps.

 

[Threpwhistle]

Thanks to you all for looking at this for me. I got this from mod traders as im in the UK Newcastle. I will get in touch with them to see if i can get a replacment. TX produce excellent equipment and i will ALWAYS use them. probably just abit unlucky on this one. The PCB had there sticker on. Answerd

 

[Threpwhistle]

Answerd, Will get in touch with MOD TRADERS.