LITEON DG-16D2S Liteon replacement

[aatif104]

hi everyone my liteon drive was not reading certain back ups after the intial flash of lt2.0 so i plugged it on to my laptop using (xbox 360 usb pro, ck3 lite with internal pc molex, probe 3) so basically i think i plugged the cable the wrong way it would fit so i turned it around and then it fit but when i loaded up jungle flasher it didnt detect the drive...

anyway i am going to buy a new drive (http://www.360upgrades.co.uk/xbox-dvdrom-liteon-drive-16d2s-74850c-p-201.html) and was wondering if the dummy file i recieved when i flashed my xbox last week are the files i need..... because i had it flashed pre 13141 but after the update it went back to stock and i can not contact the guy who done it then for the files...

thanks in advance and sorry about the long post

 

[BL4K3Y]

The dummy.bin you got from the original drive is suffice. When you get your new drive, follow this tutorial and you will be up and running again in no time .

 

[aatif104]

ok thanks i was looking for that tutorial
just to double check the key i got from flashing my xbox after the xgd3 update is still gonna work right?
thanks even if you dont reply

 

[afsilver]

ok thanks i was looking for that tutorial
just to double check the key i got from flashing my xbox after the xgd3 update is still gonna work right?
thanks even if you dont reply

yes

 

[aatif104]

ok lovely
thanks everyone

 

[aatif104]

ok just one more thing.... when i receive my new liteon drive how am i going to update it to the 02510C? does jungle flasher do it automatically?
thanks

 

[afsilver]

ok just one more thing.... when i receive my new liteon drive how am i going to update it to the 02510C? does jungle flasher do it automatically?
thanks

you choose your dummy.bin as source, then you choose LTPlus-025-v2.0.bin as target and click "spoof source to target", head over to "mtk flash" tab and click "LiteOn erase" followed by a power cycle as per described by jungle flasher, you should now have good flash properties with status 0x72, then hit write and your done!

and btw the part i just answerd was also already answerd by blakey8!!!

The dummy.bin you got from the original drive is suffice. When you get your new drive, follow this tutorial and you will be up and running again in no time .

 

[aatif104]

eshhhh... sorry about that...

Thanks everyone you really have been a massive help

As soon as i get some experience i will be sure to give back to the community

Thanks again