i have bought a liteon ''4S'' unlocked pcb but when i flashed it i think on the MTK flash tab i may have had phat selected n not slim i flashed it and not it wont let me flash it properly it... erases n then get stuck and crashes on the first 'dot' of writing... any idea folks
Liteon Unlock PCB wont let me flash it
- Thread starter Lord Cragit
- Start date
BL4K3Y
VIP Member
Post your JF log for starters, I believe the official TX unlocked PCBs have to be intro'd and such on the phat setting anyways, but I could be wrong..just seem to remember reading that a few times.
Edit: Beat me to it Bl4k3y.
Edit: Beat me to it Bl4k3y.
yea that is what i had done but i was gettin open tray error however i know my key and dump of orig drive are good as i have tested them in a sputnik unlock liteon..
now i cant intro the board is my main problem as i only get 0x80 as rather thank the required to 0x72... i noticed when i flashed the unlocked pcb it never done part of the script after flashin and verifying the part that mentions something about 0x300 or 0XE300 or something like that
im using latest jungle flasher, X360USB Pro, and CK3...
now i cant intro the board is my main problem as i only get 0x80 as rather thank the required to 0x72... i noticed when i flashed the unlocked pcb it never done part of the script after flashin and verifying the part that mentions something about 0x300 or 0XE300 or something like that
im using latest jungle flasher, X360USB Pro, and CK3...
Last edited:
BL4K3Y
VIP Member
yea latest jungle flasher and X360 and CK3.... i dont have the logs as i didnt save them dumb i know just i didnt think this was gonna happen as i have done 20-30 slim drives lmfao
Had a similar problem with a drive the other day and was pulling my hair out. Eventually got it to write fully by powering with an xbox instead of with the ck3.