Looking For alternative LCP wire diagram

[Archaicus]

Heres the situation, i have two 1.0 units that both have had failed pin headder instaltions (typical frag even though everything seemed correct, but boots to stock fine if i switch off the chip.) I have X2.6 CE and X2.6 chips avalable for ether of these units. So i refilled the solder in the holes and wire installed. Same frag issue. I have resoldred the wires serveral times, triple checking that no pads were shorted together. No matter what i do, they both frag. My guess at this point it that LPC connector is fried. Is there a diagram of alternative solder points on the motherboard that the wire connector can be hooked to? So far i havent found any despite many hours of searching.

Thanks

 

[Fantmx]

Have you tested the solder points with a multimeter to be sure that is the problem? If you are having trouble with an install you should always test the LPC with a multimeter to prevent doing more work than is necessary.