Looking for usb interface: can not continue error

[coolkiddj12]

Installed Qsbs and know i plugged it in the nand-x and installed nand-x drivers and when i go to cmd i cant dump the nand

 

[frazzeld]

Standard criteria these days...upload some photos of your instalation

 

[frayed]

search button would tell you that this error is 99% soldering related

Remember, Before You Post:

1. DO A SEARCH to see if someone has posted the problem before and whether it has been solved.

also if you have read any of the other threads about this you would see the first thing posted after the question is a request for pictures of your soldering

frazzeld beat me to it and look what was said

upload some photos of your instalation

 

[coolkiddj12]

http://imageshack.us/photo/my-images/577/img0268kk.jpg/
http://imageshack.us/photo/my-images/27/img0269yq.jpg/
http://imageshack.us/photo/my-images/820/img0267ib.jpg/

 

[Martin C]

Looks like soldering is the issue.

Check my nand-x troubleshooting sticky and check the values.

 

[knowlzy10]

looks like a possible bridge on the j1d2,

as martinc says definately looks a soldering issue

 

[coolkiddj12]

I know the small qsb was bad lucky i had a spare :http://imageshack.us/photo/my-images/151/img0271vw.jpg/

 

[knowlzy10]

no good having a spare if u knacker your motherboard:rolleyes2:

have u had much soldering experience?

 

[coolkiddj12]

A bit in junior and i'm not bad but not good.

 

[knowlzy10]

i'd seriously consider paying someone to do it correctly or you may end up with an expensive doorstop

 

[coolkiddj12]

I'll take the risk. Got bout 5 of these XD

 

[Martin C]

I'll close the thread for now. No point you keep opening threads for learning how to solder.

Don't post any more until you can solder as it's just a waste of everyone's time. there's enough info out there for you to check points etc.