Looking for USB interface device

M

mikey63366

Full Member
Apr 15, 2011
71
0
Trying to nand off my jasper.. i just did jasper hour before doing this one and it read fine. Now I'm getting Looking for USB interface device.. Don't understand why? Solder points look good.. Can program the coolrunner without out any problems..

below are pics




 
T

tennisdude516

Senior Member
Apr 8, 2011
126
0
Los Angeles
I had the same problem myself. Have you tried soldering without the QSB's?
 
T

tyiphius

Full Member
Jan 31, 2011
56
8
when you say usb device, you mean your gunna take off the QSB?
if not, then you need a nand-x and the QSBs work with the nand-x
 
T

tennisdude516

Senior Member
Apr 8, 2011
126
0
Los Angeles
Try redoing the single point on the larger QSB. That typically causes some problems and is the trickiest point to get.
 
X

XxPOYSONxX

Not saying that it's the soldering buttttt..... 99% of the time it is with this sorta problem, just give resoldering it a try :) it's happened to me before, I thought it was soldered great but I was wrong, give it a go :)
 
M

mikey63366

Full Member
Apr 15, 2011
71
0
Yes xbox has power...



I don't meter to read the voltage... not sure how I can test it.

Xbox still boots up, so I'm pretty there nothing wrong the xbox..

Guess I'll take apart know working xbox and see what happens.
 
S

smacktalker

Noob Account
Jan 12, 2012
5
0
Netherlands
to be honest the soldering looks bad, there's 2 solder points on the bigger board that look like they haven't flowed properly onto the existing points.

Did you pre-tin all the points? If not that's likely your issue as the MS solder used on Xbox mainboard needs higher temps to flow.
 
M

mikey63366

Full Member
Apr 15, 2011
71
0
I got it working finally, was bad solder points :(. took everything back off and redid it again. worked 1st time. Last time I try to solder when I'm half sleep.
 
  • Like
Reactions: keil423
You must log in or register to reply here.