ANSWERED Lost my R-jtag qsb v2?

[teknogod17]

So I lost my r-jtag jtag-alt v2 qsb and I need a new one is there some place I can buy just the qsb and not the entire kit I don' want to do out clamp wiring?

 

[BL4K3Y]

The JTAG kit #5 will work just as well.

Check with your local reseller to see if they have any in stock.

 

[oO Elite Oo]

you can still do it with out qsb, however qsb makes things alot easier.

 

[teknogod17]

that qsb has no 3v bridge for aud clamp

 

[BL4K3Y]

that qsb has no 3v bridge for aud clamp

All you need to do is stick a small piece of electrical tape underneath the end of the QSB (the point you would solder to the resistor) and then solder a wire from the transistor leg to the AUD_CLAMP point.

 

[teknogod17]

Is there a picture or diagram of this

 

[teknogod17]

Whait so let me get this trait do I need to connect the qsb to the small resister then do out clamp or do I not do resister than do aud clamp or is it either or

 

[BL4K3Y]

Is there a picture or diagram of this

All you need to do is solder a piece of wire from the point marked by the arrow to AUD_CLAMP.

 

[teknogod17]

Ok so I do that but dont solder to the resister on the xbox and if I did not need aud clamp just solder to resister?

 

[BL4K3Y]

Ok so I do that but dont solder to the resister on the xbox and if I did not need aud clamp just solder to resister?

The image I posted is for AUD_CLAMP use.

Your wire will be soldered to that transistor leg and then to the AUD_CLAMP point.

You can put a small piece of tape over the resistor so that the QSB doesn't make contact with it.

 

[teknogod17]

I know was qestion was just to simplify my qestion if I use audclamp do this and do not solder the qsb to the small resister and if a dont use it just solder to the resister. So the bridges on the v2 qsb is just to cut the circuits from the resister

 

[BL4K3Y]

if I use audclamp do this and do not solder the qsb to the small resister and if a dont use it just solder to the resister. So the bridges on the v2 qsb is just to cut the circuits from the resister

If you choose to use the AUD_CLAMP option (which I strongly recommend), you don't solder anything to that resistor.

 

[teknogod17]

Ok now I see what the tape is used for making sure it does not make contact with the resister thanks sorry for all the question i'm a nooooooooooooooooooob