lost switch for 2.6 hcip

[dctstore]

so here is the deal. i have 2 working chipped boxes, a 1.1 and a 1.0, both with a 2.6 chip. the only problem is i only have 1 switch set(enable/protect/bank). i have the wiring harness that goes from the chip out the front of the box. what wires can i cross on this wiring harness to enable the chip without the switch?

 

[dctstore]

here is what i did. looking at pins on switch, when chip is enebled, number 2 and 4 from left and 3 and 4 from right are shorted. cliped these wires and twisted together. chip boots fine......