LPC Continuity between all points, MS dash works

[fiji]

When I enable the chip, the Xbox FRAGS. I've tried both banks and no luck. When the chip is off, the Xbox boots into the MS dashboard.

The wierd part is when I test for continuity, it doesn't matter what leads I'm touching, they all seem to be connected.

V1.0 Xbox
Wire install
Xecuter 2.6CE

Any suggestions?

 

[Martin C]

Can you take a picture of your install and attach it?

Martin

 

[fiji]

I have attached two pics, one from each side. At this magnification, there seem to be cracks in the solder joints. hmmmm

 

[Martin C]

ok - I'd definitely try and redo those if I were you. Also, I don't know if it's your camera, but make sure you have the correct colour wires in the right holes.

Martin

 

[fiji]

My wires are soldered as follows. I compared these againt two install guides, they also line up in relation to a pin header install.

1 - Black
2 - Brown
6 - Red
7 - Orange
8 - Yellow
9 - Green
10 - Blue
11 - Purple
13 - Gray
14 - White

Let me know if these are incorrect.

 

[Fantmx]

http://www.teamxecuter.com/forums/showthread.php?t=7284 It looks like your wires are correct, but it is tough to tell with the colors in your pictures.

 

[Martin C]

I'm glad it wasn't just me

Martin

 

[fiji]

Success!
you were correct, bad connections on the LPC. Thanks for your patience and help.

 

[Martin C]

Glad you got sorted

Martin