LPC Pinout Using Rebuild PCB Same as 1.5 Motherboard?

[teledyne]

Howdy,

I'm using a 1.6 with the LPC rebuild PCB. It's all soldered in now, but I plan on using the wire method now.

Is the LPC pinout [besides the 5v] now the same as a 1.5 motherboard?

 

[tehsoul]

afaik, yes

why do you want to do a wire install tho?

 

[teledyne]

I've modded 2 other Xboxes, both with the wire install.
I dunno, I just like it.

Okay, so I got the wires soldered up. It's fragging now. sh*t.

In regards to the X3/1.5 wire diagram, its 1:1 [the same] besides the 5v.
3.3v and 5v lights come on. X3 light is red. And it FRAGs.

So it's not the 3.3v, 5v, or D0. So then its one of the LADs... is there anyway that the description of my problem could isolate it to one of the LADs?

Ah, also, I haven't screwed down the motherboard yet. Not sure if its a grounding issue either.

Will start to diagnose via multimeter...

teledyne

 

[teledyne]

Apparently, like all of the other times my other Xbox's FRAG'd, it was because of a unsoldered point. Of course.

The 1.5 pinout works fine as long as you're using the LPC rebuild.

Moderators: You can close this topic. Case closed.

 

[dribe_ple]

should i even update?

I canceled my LIVE since i got a ps3 and dont play online.
My two systems are currently 1.51, should i even bother to update to LT. as far as i know the only difference is the security checks and since im not online anymore would it be worth taking it apart again?

i just did my brothers lite on today with lt and i have to say the new jungle flasher is very nice! Kudos to those developers.

 

[dewdman42]

Re: should i even update?

i'm asking nearly the same question m8,i'm hesitating to update my benq to ixtreme 1.61 or ixtreme lt ,the actual fw's 1.41 so i think that's a difference between the 1.61 and the lt ,in fact the lt support all the future wave and not just for the live to be more discrete the only thing i don't care about being on live i never been to play games !!

the question is :can i even update my system from 1.41 to lt whithout recovering first the machine to the original firmware ???

please help ...!!!!!!!!!!!!!!!

 

[Onix1]

Re: should i even update?

it matters, if you have a hitachi dont update if you have benq or liteon update. If you have a sammy put some non stealth on that.

 

[dewdman42]

Re: should i even update?

cheers marshamods !!

this is very clear so let's ride then !!!

 

[dribe_ple]

Re: should i even update?

it matters, if you have a hitachi dont update if you have benq or liteon update. If you have a sammy put some non stealth on that.

one is a hitachi, which is banned anyway which i hear hitachis dont bother with the wave checks so im good.

I also have a sammy which is my unbanned system. i guess what im saying is should i update my sammy then? if an LT is coing out for it i wont bother with 1.61 but if no lt is on the horizon should i bother going from 1.51 to 61?