Hi all, I would like to know what steps I should take to upgrade from LT 1.9 (dash 13599) to LT2.0. I read in another thread that I will not be able to use my key from OFW pre-13146. Is there a newer dash than 13599 out yet? I'm pretty good at following directions, but I haven't kept up with the scene lately so I'm a bit outdated. Any help would be greatly appreciated. Thanks!
LITEON DG-16D2S LT 1.9 -> LT 2.0
- Thread starter raphytaffy
- Start date
BL4K3Y
VIP Member
Load your dummy.bin as the source firmware in JungleFlasher (use the latest version), load LTPlus-025-v2.0.bin as the target, click spoof source to target, click the MTKFlash32 tab, click Lite-On Erase and follow the prompts, when you get Status 0x72 (Vendor mode), click Write and once you see "Write Verified!", click Outro/ATA Reset 
.
.Great! The process sounds the same then. Is there a newer dash that I will need to upgrade to or is 13599 the newest one out?
BL4K3Y
VIP Member
Dashboard version 13599 is the latest full dashboard however, I believe there was a beta preview released a couple of days ago but that shouldn't affect anything.
Dosk3n
VIP Member
Thanks Dosk3n. Do you know if it is just the preview like blakey8 mentioned? If it's just a preview, I can live without it for the time being. If it's a dash update that we are forced to update to, then I will flash back to stock, update, and then flash to 2.0.
Looks like another successful flash. Thanks! Two more quick question: are there any games that worked on 1.9 but need to be reburned for 2.0? Are there any known games that still do not work on 2.0?
Dosk3n
VIP Member
Check your Backup ISO's through ABGX (XGD2 & AP2.x) if there are any updates then burn new backups :wink:
The latest XGD3 games will play with LT+2.0 but please make sure you only use backups of your original discs (ripped with latest 0800 v3 FW) because you cannot check them through ABGX yet :eek2:
BTW...The latest dash version is 13604 (check in system settings....etc)...
Last edited:
raphytaffy did you end up using the old dummy.bin? I have the original one that I extracted when I first got my xbox. Will that work or should I update to the newest dash first and then re-extract and use the new dummy.bin?
Thanks.
Thanks.
Yeah, I did. Load your old dummy.bin as source fw, load stock fw as target fw (not sure which drive you have) to flash back to stock, update your dash, and then follow the steps that blakey8 suggested to flash to 2.0. Good luck!
Yes, This is the same words Ubergeek always tell us that "YOU SHOULD ALWAYS REVERT TO STOCK FW BEFORE ANY MAJOR UPDATE - ALWAYS, ALWAYS, ALWAYS !!" :biggrin: