HITACHI NON-79 LT 2.0 not playing xgd3

[sylver989]

O just flashed Lt 2.0 in one Hitachi 47 and read mw3 burned in verbatim but doesnt read off printed verbatim used liteon ihas on both.

People just try diferent brands of verbatim better grade will work 100%

 

[skater411]

im having this issue to with my 79 drive reading all backup an stock just not back up of xdg3 games

 

[xboxchi]

i have the same problem with my friend Hitachi 79 LT+2.0
anything new for this fix yet?

 

[Artxx]

I confirm also my Hitachi 59dj all XGD2 backups works great expect XGD3 backups dont work at all!

 

[dragontm]

All those having problems with Hitachi 79's some good news

<c4eva> hitachi 79 fix incoming!

but dont do the usual and ask when, it will be released when its ready

 

[AkhmedovIR]

I have the same problems. I have 2x Xbox with Hitachi 78. one with 13599 dashboard, another with 13604. I flash LT+2.0, afer this i put xgd3 dvd (3 different) i see only PlayGame without cover (but i sow it before). When i start games i get error message with asking to clean the disc...

 

[fourcz214]

Hey Pas7680,

I have the same problem. I have a Hitachi 59 with LT 2.0, and the disc says "play game" but no game picture ID shows up. When I press A to play game, it goes black, then it says "clean disc." However, my original XGD3 works fine and my XGD2 backups work fine.

 

[AkhmedovIR]

I think we may wait fix soon

 

[Atariwarrior]

I have a Liteon 0251, Hitachi 59, and Hitachi 78 console. All the consoles have LT+ 2.0 and dashboard 13604 installed. I never go online with any of these consoles. I burned XGD3 backups with the base iHAS burner with LT+ Burner MAX firmware using IMGBurn and Verbatim MKM 001s. I burned at 2.4X as recommended with OPC unchecked in IMGBurn.

All the XGD3 backups worked on my console with the Liteon 0251. However, when I tried these same backups on the Hitachi consoles, some worked on the Hitachi 59 and not on the Hitachi 78 and vice versa.

I adjusted the pot on the Hitachi 59 and was able to get 3 of the 4 XGD3s that weren't working on the 59 to work. The pot is now at 2.9 k-ohms and I'm not sure if I want to adjust any lower because I may burner out the laser.

I still haven't messed around with the Hitachi 78 yet.

Are Hitachis with the LT+ 2.0 really that sensitive to the burn quality of the backups that the pots have to be adjusted or is is the Hitachi LT+ 2.0 firmware that is at fault? Anyone else come across the same situation?