GENERAL LTU Help pleaseeeeee...

C

coisadelouco

Junior Member
May 26, 2011
16
0
I recorded the sheer confusion of a key on a Hitachi 502 LTU :facepalm:, blz smoothly, realizing the error found the correct key that was to have been one recorded in 1175 ....

I would just put the cd in place to run 0800 vendor mode and write the correct key, but ..... she did not enter into vendor mode :confused:..........

Putting these LTU in vendor mode after they are already engraved with a key???:confused:
 
F

FlipMode

VIP Member
May 4, 2005
296
0
Woodstock, Ontario
You asked this yesterday, the reason you got no response is we have no clue what you are talking about.

Have you extracted your key from the CPU?

So you thought you have a Hitachi but you have a Lite-on 1175?

Did you follow this POST HERE?
 
C

coisadelouco

Junior Member
May 26, 2011
16
0
I've done several LTU, got confused with the folders on my PC and write the CFH Hitachi with files KEY and C-R of drive 1175 .............

But now , i need write CFW 1175 with files KEY and C-R of 1175 drive , but the LTU PCB don't enter in vendor mode again, only give status 0x51 - 0x80 ....


* I put the cd "active.iso" into the drive, wait he read , but when I click "intro/Device" he ask me if i have wait a minute bla bla bla , Yes or not ....
 
Last edited:
C

coisadelouco

Junior Member
May 26, 2011
16
0
Dont have log , only dont enter em vendor mode .....

and i using CK3 and USB PRO V2 ....... and all the others LTU whith i make works ...
 
You must log in or register to reply here.