I want to ask , is it enought to read nand using TX JRunner NDX CR QSB & R-J Programmer (Obviously lol) from slim console to have the files required to be used on LTU Pcb both for DG-165S and for DL10N or i need Coolrunner too ? Thanks for the answer :smile:
LTU PCB question
- Thread starter martynas931
- Start date
BL4K3Y
VIP Member
You need to glitch the console to get the CPU key.
You need to use the CPU key to decrypt the key vault (where the DVD key is stored).
You can also grab the DVD key through XeLL (usually, but it sometimes doesn't show if the DGX is used).
You need to use the CPU key to decrypt the key vault (where the DVD key is stored).
You can also grab the DVD key through XeLL (usually, but it sometimes doesn't show if the DGX is used).
BL4K3Y
VIP Member
You're already here... :rolleyes2:.Can you send me the website where i could have a look how to do it all
BL4K3Y
VIP Member
I could, but searching the forum would bring you the same results.
You can always post a request in the relevant section to have somebody obtain the drive key for you.
You can always post a request in the relevant section to have somebody obtain the drive key for you
.Thx BL4K3Y for a help if i run into any troubles i will post in appropriate place so that some of the pro's could dump the key for me .