FIXED ltu2 1175 not entering vendor mode

unkn0wn.92

VIP Member
Jun 30, 2011
665
48
AMM,Jordan
hey guys i have ltu2 pcb it was brand new on i tried it yesterday dg15ds 1532 fw and it worked fine now the pcb has 1532 fw and i have 1175 fw igot the key created the ltu2 fw but when im trying to get the pcb into vendor mode its keep loading i picked the phat as always
any ideas ?
 

WarezRat

VIP Member
Dec 24, 2003
310
0
Northern Hemisphere
Hey I am having the same problem with a DG-16D5S, it refuses to go into vendor mode. I have tried everything that I have read to no avail. Is there anyone out there who can lend me some advice? I have tried different JF's, it shows up as 1175 FW, it is a genuine TX, it doesn't have a switch like the 16D4S board. I am using 360 pro, have reprogrammed a 16D4S just to make sure my equipment works (without probs). ANYone have any ideas?
 

Jrok96

Senior Member
Oct 12, 2015
114
18
Hey I am having the same problem with a DG-16D5S, it refuses to go into vendor mode. I have tried everything that I have read to no avail. Is there anyone out there who can lend me some advice? I have tried different JF's, it shows up as 1175 FW, it is a genuine TX, it doesn't have a switch like the 16D4S board. I am using 360 pro, have reprogrammed a 16D4S just to make sure my equipment works (without probs). ANYone have any ideas?
even after switching the radio button from slim to phat?