RGH M$ Refurb - 25C reading block 0

[mm53668]

Tried dumping a slim that Microsoft Refurbed on 6/21/12 - I get 25C reading block 0 so obviously can't check the KV .

Assuming this means its been patched? Or is there another point that the KV is held at?

BTW its on dash 14719

 

[big_ted]

The KV will still be in the dump else the console wouldn't have any ID, IT'll be shoved to the spares at the end, if you open up the dump with one of the many programs available, and move the block from spare back to the front on the image you'll get all the details you need, I think jrunner does it automatically for you anyways.

Ted

 

[Martin C]

Block 0 is SMC. Block 1 is KV.

As big_ted says, you should have data around the end of your dump.

 

[mm53668]

Ill have to double check the exact info Again this evening but after dumping jrunner showed no console info and couldnt create ecc

 

[Martin C]

You might need to manually move the data.

 

[mm53668]

OK thanks I got it. Couldn't find where to move it within J-Runner but put it in Nandhealer and it moved 3FF to its place and everything works just fine.