Major opps, need help!!

T

tdswanson

Noob Account
May 8, 2006
3
0
I tried to solder in a xecuter 2.6 into my version 1.6 xbox. but I totally screwed up. when I tried to solder one on my points i held the iron to long and melted the board where to solder point was supposed to be. now my xbox wont even fire up anymore. I was wondering if any of you knew the scamatics of the board so that I could somehow repair my board.

This is a link to the page which I was using for instructions for install.

http://www.team-xecuter.com/x3/tutorials/x3pin16.htm

now the one I totally messed up is the RED:LAD2

I totally destroyed the solder point and trace on the board, is there any way I can fix this?? If any one can help it would be greatly appreciated, thanks..
 
Last edited:
T

tdswanson

Noob Account
May 8, 2006
3
0
never mind I ended up and took a piece of wire and rebuilt the trace that I destroyed, the solder point seems to be erelavent cause the xbox boots and plays properly, but now I am stuck with triing to find a bios to flash this chip with, I read the forums and it told me to use the bios of "x2 5035 v16 plus" but I have searched everywhere including xbins and cannot find it anywhere. Is this the right flash to use and can someone hlep me to find it, thanks.
 
You must log in or register to reply here.