Messed Up Stby_Clk during RGH
- Thread starter benny679
- Start date
nofeloniesyet
VIP Member
scratch the paint off the via at the end of the trace and solder wire from via to side of resistor.bam done
If you dont have Kynar wire find some makes for easy trace repair
If you still want to RGH that console you will have to double that wire up to complete the circuit
PS I hope that console is on a old dash RGH 2 Falcon on Rev C can be challenging
If you still want to RGH that console you will have to double that wire up to complete the circuit
PS I hope that console is on a old dash RGH 2 Falcon on Rev C can be challenging
Now that I have that fixed, how should I connect that point to the coolrunner? Should I solder 2 wires to the trace or find an alt?
nofeloniesyet
VIP Member
alt on backside of mb ft2r2 i believe.real close to one the holes by southbridge.
nofeloniesyet
VIP Member
No.
I soldered to the wrong side of the resistor. Upon moving the wire, the resistor came off. I then soldered in a full-sized resistor. Then one of the wires got caught on my soldering gun and it pulled the trace near the HANA. So then I tried the point on the back and the console doesn't turn on. I'm having a jolly f**king time.
nofeloniesyet
VIP Member
alt point on back is not going to do you anyyyy good unless the trace from hana to that via is fixed,and if you have now pulled the entire trace up all way to hana,that box is a goner.
Not all the way. The trace is still there, the resistor and little solder point are gone.
Fixed it, thanks to my friends at Se7enSins - a person w/ an RGH shop there showed me some alternate points to use.
I'll let you guys know how it goes when I hook up the CR Rev C.
I'll let you guys know how it goes when I hook up the CR Rev C.