hello am new to this and still learning and i have a question if am doing the right thing around modding my 360.
first i downloaded everything required
bootmaker 5.2
and bin to the computer xtreme (52a)
i connected a sata cable to my computer and 360 Powered my computer
went into dos and powered my 360, typed in xread and of course my serial after that it reads and doesnt display the drive i tried re plugging the sata cable else where but the same thing happens ? whats the problem what am i doing wrrong ? now my motherboard is gigabyte 965p dq6 and i check on some tutorials and it listed intel ich5-8 modules so am sure its Compatible. am confused on if i still need to remove the transistor that i read on the tutorials because am using ms28 and not ms25 or could it been done this way and do i need via card ?? plz if someone can give me advice i would appriciate it. thx again !!
first i downloaded everything required
bootmaker 5.2
and bin to the computer xtreme (52a)
i connected a sata cable to my computer and 360 Powered my computer
went into dos and powered my 360, typed in xread and of course my serial after that it reads and doesnt display the drive i tried re plugging the sata cable else where but the same thing happens ? whats the problem what am i doing wrrong ? now my motherboard is gigabyte 965p dq6 and i check on some tutorials and it listed intel ich5-8 modules so am sure its Compatible. am confused on if i still need to remove the transistor that i read on the tutorials because am using ms28 and not ms25 or could it been done this way and do i need via card ?? plz if someone can give me advice i would appriciate it. thx again !!