Hi all I like some help with flashing a slim as not done one before it Model DG16D4S ,what tool do i need got usb pro and few other bits thanks all.
Model DG16D4s
- Thread starter besty
- Start date
Have you checked out the "Jungle Flasher Step-By-Step Instructions"
You'll find all your answers in there.....
You'll find all your answers in there.....
HI not yet was asking before I start to make sure I dont mess it up as I only done fat ones up to now ,so did not want to mess my first slim up thanks.
---------- Post added at 01:09 ---------- Previous post was at 01:05 ----------
It Fw ver 0401
---------- Post added at 01:09 ---------- Previous post was at 01:05 ----------
It Fw ver 0401
I don't want to be accused of 'Mini Modding' but the first requirement prior to asking for help is to research....
You will get a much more informed response/help after you have done the above....
TBH & IMHO all your answers are within that link I posted for you....end of spoon feeding session
You will get a much more informed response/help after you have done the above....
TBH & IMHO all your answers are within that link I posted for you....end of spoon feeding session
BGAMods
VIP Member
Go through the Jungleflasher tutorial first. At least 3 times. If you have questions ask before mucking up your box.
Check out Uber's post to find out what type of chipset you have because you may need additional hardware.
You could always take the easy way out and use the xecuter replacement pcb.
Good luck!
Check out Uber's post to find out what type of chipset you have because you may need additional hardware.
You could always take the easy way out and use the xecuter replacement pcb.
Good luck!
Last edited:
If you take your time and read on how to properly execute the hack and you will do fine.
I had no problems with my first kamikaze. I'd suggest using the dremel method or another group sells an unlock template with a drill bit. The dremel method works fine if you take your time.
I wouldn't recommend using a soldering iron though.
The worse case is you fork it up and will have to buy a xecuter unlocked pcb.
I had no problems with my first kamikaze. I'd suggest using the dremel method or another group sells an unlock template with a drill bit. The dremel method works fine if you take your time.
I wouldn't recommend using a soldering iron though.
The worse case is you fork it up and will have to buy a xecuter unlocked pcb.
Last edited: