MS25 flashed wit 1.2revC

[TradingWise]

Hello,

I just flashed my ms25 with iXtreme 1.2revC but have some questions. I have an ms25 that was already flashed but I don't know with wich Xtrme firmware. I didn't have the orig.bin.

So i decided to flash it with the newest iXtreme firmware but had some problems. First of all i couldn't dump the firmware (iDump) only if i used the 10 second trick, so i think my drive was spoofed as a ms28?

The dump went ok but and after the dump the green light of the 360 (in the middle of the rings) was flashing. I shut down the PC and 360. When i started the 360 again three red lights were flashing, is that normal?

I did proceed with Iflash and the flash went ok.

The question: Is it normal after the firmware dump that there are three red lights flashing?

conra700

 

[lang]

No that's not normal, is it still doing it now? Sometimes they intermittently show 3 Red Lights, then if you shut it off and try it later it will play fine for a while, until they finally die for good and then you'll get 3 Red Lights every time you boot it. You're probably going to have to do the x-clamp fix on it.

http://copronymous.com/wp-content/uploads/2007/05/fix-for-the-3rlod.pdf

 

[TradingWise]

Ha Ha :-( You are completely right. I did an dashboard update and know the Xbox freezes a lot of times and sometimes i get the RoD (light 2 / 3/ 4)

Do you have a good link for the x-clamp modification?

 

[lang]

Do you have a good link for the x-clamp modification?

Umm, I guess you didn't bother clicking the link above? lol

I actually just finished fixing one with that method about an hour ago, it has worked on every 360 I've done so far.

 

[TradingWise]

I saw the link later.......I just opened the 360 again and did the bolts a little bit more loose. Now the 360 is working again but I will do the X-clamp method soon.

thanks