I have x3 installed. flashed latest bios. have installed maxtor 120 gig hd. when booting to ms dash, flubber and misrosoft xbox screen load ok then lose signal (back to normal tv for couple of seconds) then get service required message. all works ok with x3 bios launch and evox. also plays disks and hard drive backups ok in evox mode, have hd locked. have rechecked and uploaded all c and e drive backups many times so are ok.if i put old drive back in all works fine so obviosly to do with new drive. have even tried second brand new drive but just same. all files are identicle to originals what am i doing wrong. help please.
msdash boot problem with maxtor 120
- Thread starter frogman2
- Start date
Did you make sure you hadn't deleted the XFT (font files) and that they aren' 0 byte files. I had completely removed the original dash and then wanted it back. and could not get it to start. I then FTPed in and noticed that one of the XFT files was 0 bytes. I replaced it with a back up I had and the dash booted fine.
jumper setting are set to cable select. my font files are fine, i have double checked all my files they are exactly as original hard disk my maxtor 120 hd is model number6Y120L0 which a lot of you seem to using succesfully i am completely stumped by this.
Where to start?
Well my friends, it has been a while since I have been around. I used to have a modified DVD firmware until MW2 came out, but as you can guess, my xbox was one that was banned in that wave. I since then bought a new Xbox and I have not been backing up my games. I believe since then a lot has changed? Because I flashed my BENQ VAD6038 drive with ix 1.41 1.5 and 1.6. My new xbox is manufactured 09/19/2009 so I assume it has a LiteOn drive? Where do I start? I still have the VIA PCI card so I just need some guidance of where to go.
Well my friends, it has been a while since I have been around. I used to have a modified DVD firmware until MW2 came out, but as you can guess, my xbox was one that was banned in that wave. I since then bought a new Xbox and I have not been backing up my games. I believe since then a lot has changed? Because I flashed my BENQ VAD6038 drive with ix 1.41 1.5 and 1.6. My new xbox is manufactured 09/19/2009 so I assume it has a LiteOn drive? Where do I start? I still have the VIA PCI card so I just need some guidance of where to go.
